Lifetime #7525 Manuel d'utilisateur

1**U.S. and Canada customers ONLY**IF ASSISTANCE IS NEEDED,DO NOT CONTACT THE STORE!!!CALL OUR CUSTOMER SERVICE DEPARTMENT at 1 (800) 225-3865HOURS: 7

1031.1 Rest the Backboard (AU) and Rim (AO) on cardboard to prevent scratching.3129.1 Tighten the Nut until it is ush with the Bolt.2930.1 Attac

11HD9185Required For This Page: MA(3)3/4” WrenchesMH(3)1/2” Socket WrenchHammer/MalletElectric Drill32.1 Remove the plastic lm from the Backb

12Note: Please call our Customer Service Department at the number on Page One to obtain replacement Nets. Our Nets are shorter than average

133939.3 Place the Wood Block (AJ) on top of the pole and strike with a hammer six or seven times.**AT LEAST 2 ADULTS REQUIRED FOR THIS STEP**AJTPMPB

14Operation of the height adjustment systemWHILE TRANSPORTING THE PORTABLE SYSTEM, USE CAUTION TO PREVENT THE MECHANISM FROM ADJUSTING.The adjustable

15FAUTE DE NE PAS SUIVRE CES AVERTISSEMENTS, VOUS RISQUEZ DE CAUSER DES BLESSURES GRAVES ET/OU DES DOMMAGES À L’ÉQUIPEMENT.SI NO SE OBEDECEN ESTAS ADV

16LIFETIME BASKETBALL EQUIPMENT5-YEAR LIMITED FACTORY WARRANTYTHE MANUFACTURER RESERVES THE RIGHT TO MAKE SUBSTITUTIONS TO WARRANTY CLAIMS IF PARTS AR

17

2PARTS LISTID Part # Description Qty TP 1006441 Top Pole 1 MP 1006443 Middle Pole 1 BP ZA08004 Bottom Pole 1 AB DD00800 Net 1 AC 50202

3ID Part # Description Qty Handle Hardware (1017923)HA 302007 3/8” x 6 1/2” Hex Bolt 2 HB 300101 Release Pin 1 HC 302008 3/8” Centerlock Nu

4POLE SECTION IDENTIFICATIONIdentify the pole sections before beginning assembly. Failure to assemble the pole sections correctly may result in severe

5For a nonpermanent installation of your basketball system, a Ground Sleeve provides an alternative to cementing the pole into the ground.

6MJMTHCSmall holes Large holesRequired For This Page:9/16” Wrenches(2)(2)(2)MJAMHCMTBCBC(2)HD9185ScrewriverTP6.1 Completely tighten the Nuts.6PA(1)1

7Required For This Page:9/16” WrenchesScissors/Wire Cutters/Pliers11.2 Tighten the Nut until it is ush with the Bolt.1111.1 Line up the Rear Lifter

8Required For This Page:PliersREAPAQRE17.1 Hold the Backboard Brackets (AP & AQ) together and slide the U-Bolt (RE) through the hole

9Required For This Page:1/2” WrenchElectric Drill/ScrewdriverRGRFRFRJ25.1 Place the Spring Retainer Plate (RJ) and secure with Nylock Flange Nuts (RF